The X1541 cable


You need the following parts to build this cable:

  • One solderable 6-pin male DIN plug (Commodore serial plug)
  • One solderable 25-pin male plug (PC parallel plug)
  • A shielded 4-wire or unshielded 5-wire cable of, preferably at most, 2 meters

Step 1. Solder one end of the cable onto the DIN plug.

Step 2. Solder the other end of the cable onto the parallel plug. You should have the following connections:

DIN plug Parallel plug
 2, GND  18-25, GND
 3, ATN   1, Strobe
 4, CLK  14, AutoFeed
 5, DATA  17, Select
 6, RESET  16, Init

Circuit diagram:

[X1541 cable]

You can find the description of all parts used on the diagrams at the legend page.

Source: The Joe Forster-STA homepage